Workrite Sierra HX Electric Workcenters - Manual (Page 2)

2 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Sierra HX Electric Workcenters - Special Settings
3
4
Adjust Starting Digital Height Readout
(Use if you have a worksurface that is not 1⅛" thick, which can cause inaccurate readout of the
lowest height)
Lower the table to the lowest position and measure the height from the floor to the top of the
worksurface. (not shown)
Hold Up and Down Arrow simultaneously for 5 seconds. While keys are being held, ‘---‘ will appear
on the display.
After 5 seconds the display will revert to showing the height.
Once the height is displayed, press Up or Down Arrow until display shows actual measured height
for the worksurface.
Example: if the table top is 22.8" off the floor, press Up Arrow until display shows 22.8.
Press the “SET” button with a ballpoint pen. ( Do NOT use a paperclip - it may damage the electronics ).
Note: Height readout must be readjusted separately for inches and centimeters.
Table Locking Feature
To Lock:
Press and hold the “SET” button with a ballpoint pen ( Do NOT use a paperclip - it may damage the
electronics) until the control box clicks two times – The table will now be locked and will not move
when any buttons are pushed. “LOC” will appear on the display when the table is locked.
To Unlock:
Press 1, then 2 and then 3 to unlock. *The default unlock code is always 1-2-3.
(After 1 is pressed, 2 must be activated within 2 seconds, and 3 must be activated within 2 sec-
onds after pressing 2. Otherwise the sequence must start over from 1.)
a
b
a
b
c
d
e
or +
2 3 1
5
10
15
20
25 30 35
40
45
50
55 60
c e
or +
2 3 1
5
10
15
20
25 30 35
40
45
50
55 60
a b
b d