Workrite Pinnacle 2 No Positive Tilt User Manual
No possitive tilt kit, Pinnacle 2 arm
Workrite Ergonomics
1450 Technology Lane
Petaluma, CA 94954
ph: 800.959.9675
fx: 800.930.8989
www.workriteergo.com
© 2008 Workrite Ergonomics, Inc. All Rights Reserved
No Possitive Tilt Kit
Pinnacle 2 Arm
INSTALLATION AND USE
4
1
Attach the Knob
While holding the opposite wedge
block in place, screw the adjustment
knob onto the carriage bolt.
Insert the No Positive Tilt Block
While holding the opposite wedge
block in place, slide the No Possitive
Tilt Block onto the carriage bolt.
The nose of the block should fit into
the slot on the arm.
Remove the Knob
Unscrew the adjustment knob.
Take care not to lose the spring
contained within.
2
3
NO POSITIVE TILT BLOCK
1X
CONTENTS
IMPORTANT
Be sure both blocks
are aligned with the
left and right slots.
!
#1500081
Remove Old Wedge Block
Slide the old block and spring off the carriage bolt.
It may be necessary to tilt the arm back to remove the block.
HOLD OPPOSITE
WEDGE BLOCK IN PLACE
ALIGN NOSE
WITH SLOT