Workrite Cascade Assembly Instructions for 2-Leg Counterbalance Workcenters - Manual (Page 6)

6 of 8 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Workrite Cascade Workcenter - Assembly Instructions
Attach the Manual Release
Do not remove the safety tag or activate the Manual
Release Trigger. Serious injury or damage may occur!
If you have a Workrite worksurface:
Position the Manual Release over the pilot holes near front edge of worksurface.
If you do not have a Workrite worksurface:
Align the Manual Release so the outermost edge of trigger is ¼" from the edge of worksurface and
the cable loops freely from the Base Assembly. Mark and pre-drill screw pilot holes into underside
of worksurface with 3 ⁄
32
" drill bit.
Do not drill any more than ¾" deep
and damage your worksurface top!
Attach Manual Release with the five #8
× ⅝" Pan Head Screws (H) using the
#2 Phillips head driver.
Attach Manual Release cable
to worksurface in a convenient
location with Cable Loop (J)
using the #2 Phillips driver.
DO NOT ACTIVATE MANUAL
RELEASE! Activation of the
Manual Release at this point
may result in serious injury or
damage to your workcenter!
front
Attach Feet
Attach Feet (C) to bottom of legs with Socket Head Cap Screws (F),
using the Allen Wrench and tighten securely. Be sure the longer end
of the foot goes towards the front.
H
H
a
a
F
b
b
c
c
5
C
C
6
a
J
front