Welch Allyn Proxenon Headlight And Fiber Optic Cable - User Manual - Manual (Page 16)

12 Chapter 2 Welch Allyn ProXenon Headlight and Fiberoptic Cable
Connections
1. Insert fiberoptic cable light source end into Storz port of the
ProXenon 350 Surgical Illuminator.
2. Turn ProXenon 350 Surgical Illuminator on. Adjust light
intensity to the minimum level necessary for adequate
visualization.
Headlight Operation
1. Prepare the headband.
a. Coolvent headband:
Remove and discard used pad set and replace with new
pad set REF 90242.
Use the headband adjustment knobs to open the
headband to the largest size.
Place the headband on your head with the luminaire
centered between your eyes.
Tighten the crown adjustment knob. The headband
should rest just above the eyebrows.
Tighten the rear adjustment knob for proper fit.
Caution Overtightening adjustment knobs will
damage the gear teeth.