Citizen Systems iDP-3535 - Manual (Page 30)

iDP-3535 User’s Manual
CITIZEN 30/38
For U-type only (USA type)
Your iDP3535 is equipped to drive up to 2 external device – Paper Winder and / or Cash Drawers.
The 4 pin molex connector and the first driver of the modular connector (pins 2 & 3) are shared by the same driver
and only one device can be connected to this driver. Acceptable combinations of configurations are:
A) No external devices connected.
B) One Cash Drawer connected to 4-pin molex connector. Set DIPI-6 OFF.
C) One Paper Winder connected to 4-pin molex connector. Set DIPI-6 ON.
D) One Cash Drawer connected to Modular Connector Drive 1 [pins 2 & 3].
Set DIPI-6 OFF. (Note that the 4-pin molex connector cannot be used.)
E) Two Cash Drawers connected – Drawer 1 connected to 4-pin molex connector – Drawer 2 connected to
Modular connector Drive 2 [pins 4 & 5]. Set DIPI-6 OFF. (Note that the Modular Connector Drive 1
[pins 2 & 3] can not be used.)
F) Two Cash Drawers connected – Drawer 1 connected to Modular connector Drive 1 [pins 2 & 3].
Drawer 2 connected to Modular connector Drive 2 [pins 4 & 5]. Set DIPI-6 OFF.
(Note that the 4-pin Molex Connector cannot be used.)
G) One Cash Drawer and One Paper Winder connected. Paper Winder connected to 4-pin molex connector
Drawer 2 connected to Modular connected Drive 2 [pins 4 & 5]. Set DIPI-6 ON.
(Note that the Modular Connector Drive 1 [pins 2 & 3] cannot be used.)