Universal Remote Control (URS) SL-8000 - Manual (Page 32)

Programming Memory Buttons:
1
Select the section that you wish to program the Memory
Button in by pressing the corresponding Device Button
(AUD, or SAT) and MUTE button, simultaneously. SET
will appear in the LCD.
2 Press one of the Memory Buttons (M1, M2, M3, M4, or
POWER) into which you wish to store the functions.
M(1-5)_# #
will appear in the LCD.
3 Press in up to fifteen commands that you want stored in
that Memory button. Each successive button selection
will appear as M(1-5)__(01-15) in the LCD.
You can select functions from another mode by first
pressing the corresponding Device Button and then the
buttons where those functions are located in that mode.
The pressing a Device Button also counts as one com-
mand.
Note: Each insertion of a Device Button adds a 1/2 second
delay to the command sequence.
4 Press the CHANNEL UP button to store your selections.
SAVE
will flash three times in the LCD to confirm the
programming.
Note: It can take up to 15 seconds to send out 15
commands from a memory button.
Please continue to point
the remote control at the device(s) until all the commands on the
Memory Button have been sent out. This will ensure that all the
commands are received by the device(s).
24 24
Advanced Features
Example: Memory Button Programming.
To program Memory Button M2 in the Audio mode to send
the following commands: turn on the Audio receiver, turn
on the TV, turn on the VCR, and turn on the satellite
receiver.