Universal Remote Control (URS) A6 User Manual
Page 9
Page 9
I
F
Q
UICK
S
ET
-U
P DID NOT WORK
,
TRY THIS
NEXT
:
Three-Digit Code Set-Up Method
STEP 1: Find the 3-digit code numbers assigned
to your brand from the lists in the back of this
manual. The codes are listed by component
category (i.e., TV, VCR, DVD, etc.), then by brand
name. For instance, if you would like to locate a
code for a Sony television, first locate the TV
category and then look for the Sony brand.
STEP 2: Once you have located the 3-digit codes
for each of the components that you wish to
operate with your URC-A6, write them ALL down
on a piece of paper. It’s important that you write
down all the codes listed for your brand because
only one code is going to work with your
component.
STEP 3: Manually or using your old remote, turn
on the component you want to program—for
example, to program your TV turn on your TV set.
STEP 4: On the URC-A6, press the Component
button that you want to program (in this case the
button that says TV) and the SELECT [SEL] button at
the same time. Hold down both buttons for 2
seconds until the TV Component LED light turns
on. This signals that you are in programming mode.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds,the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
COMPONENT
BUTTONS
SELECT
BUTTON