Tycon Power UPS-ST2424-50-UBNT - Manual (Page 5)

5
STEP 10: If batteries are installed
on their side make
sure to apply an insu-
lator to the top of the
battery terminal to pre-
vent the battery terminals from shorting to the metal en-
closure in case the battery shifts inside the enclosure
during an earthquake.
STEP 11: Disconnect the green front connector
from the controller. Connect the battery cables to the battery. Be sure to
observe polarity. Black wire connects to battery negative terminal and
BAT(-) terminal on the controller. After connecting the batteries, plug
the green connector into the controller. When a fully charged battery is
connected, the Green LOA LED should light on controller and the LED’s
on the 5 port switch should power up.
Note: The
green con-
nector