Tycon Power UPS-ST2424-50-UBNT - Manual (Page 2)

2
Qwik Install
STEP 1: Add Grounding Wire Between Door and Enclosure: Remove
plastic covers on copper studs
on inside of door and inside of
enclosure. Add jumper wire be-
tween 2 copper studs and use
copper washers and nuts to se-
cure.
STEP 2: Add wire feedthrus into
the bottom connector plate. Attach the connector plate to the bottom of
the enclosure using self tapping screws provided.
STEP 3: Install hole plug in drain hole in bottom right corner of the en-
closure.
STEP 4: Mount the DIN rail to the door using screws provided. Mount
any extra equipment to the orange backplate and secure the backplate
in the enclosure. Note: The DIN rail can also be mounted to the orange
backplate or sides of enclosure if desired.
STEP 5: If pole
mounting the enclo-
sure, assemble