Tycon Power RPST-PowerVent - Manual

RPST-PowerVent
Power Enclosure
Ventilator
▫ ENC-ST Enclosures
▫ RPST Systems
▫ UPS-ST Systems
Congratulations! on your purchase of the RPST-PowerVent.
Please take a moment to review this Qwik Install Guide before
installation to the Enclosure.
Recommended Tools: Phillips Screwdriver
Qwik Install
STEP 0: The RPST-PowerVent replaces the bottom access plate in the
ENC-ST steel enclosure.
STEP 1:
Remove the 8 screws from the existing access plate and re-
move the existing access plate. Remove the cable glands and hole
plugs from the existing plate.
STEP 2:
Assemble cable glands and hole plugs to the RPST-
PowerVent plate.
STEP 3:
Install the RPST-PowerVent to the enclosure with the fan on
the left side. Tighten 8 screws loosely and then tighten to seal the gas-
ket against the bottom of the enclosure. Don’t over tighten or plate will
be bent and gasket seal won’t work properly.
STEP 4:
Route red and black wires to a 12VDC power source. Connect
red wire to V+ and black wire to V-.