Torbal DRX300 Manual - Manual (Page 7)

Instruction Manual - TORBAL DRX 5 Series
CHAPTER 5.
UNPACKING THE BALANCE AND GETTING STARTED
1. Carefully remove the scale and pan from the packaging and place them on a stable base where the scale will not be
affected by any mechanical vibrations or air movements.
2. After removing the pan base and the pan from their packaging, carefully install the pan base onto the scale by placing
it on the pan support located in the middle of the scale. Once the pan base has been installed, gently place the pan on
the base as shown below.
3. Once the pan has been installed, level the scale by adjusting the rear feet until the level indicator shows the “air
bubble” is in the center position of the sight glass. The level indicator is located on the rear left side of the scale.
7