Symtech LCA2 EZ - Manual (Page 11)

11
Question: Can the “Visual Assist” meter measure light intensity?
Answer: The “Visual Assist” meter DOES NOT MEASURE LIGHT INTENSITY. It assists in locating the
highest value reading of that particular lamp. If a light intensity meter is an instrument your facility
would like to procure, SYMTECH offers the “AIM 200”, a hand held, self-contained precision
instrument specifically designed for measuring automotive light intensities.
Question: Why does the “Visual Assist” meter have a higher reading on one side of the car than the other?
Answer: Most vehicles will have lamps of varying intensity and patterns. Just use the meter and adjust to the
highest value reading for that particular lamp.
Question: Can I use the “Visual Assist” meter to help line up the optical head with the headlamp?
Answer: YES. While observing the meter, roll the LCA 2 EZ back and forth horizontally and raise and
lower the optical head vertically until you achieve the highest metered reading.
Question: How do I change the batteries in the “Visual Assist” meter?
Answer: The meter does not have batteries, power is provided by the light of the headlamp.
Question: Is there a calibration procedure for the “Visual Assist” meter?
Answer: NO calibration of meter is required.
WARRANTY
All Symtech Corporation products are warranted to be free from defects in material and workmanship under
normal user service for a period of one year after the sale of the product. Exception to this policy will be
individually evaluated and must be approved by Symtech Corporate. The sole obligation under this warranty shall
be to repair, or replace any defective products or parts thereof, which upon examination are deemed to the
seller’s satisfaction to be defective.
The warranty shall not apply to any product, which has been subject to misuse, negligence, or accident. The
seller shall not be responsible for any special or consequential damages and the warranty as set forth is in lieu
of all other warranties, either expressed or implied. However, the seller makes no warranty of merchantability in
respect to any products for any particular purpose other than that stated in literature and any applicable
manufacturer shop or service manuals referred to therein, including any subsequent service bulletins.
All Symtech Corporation Optical Headlamp Alignment Systems have been tested by an AMECA accredited
independent laboratory and found to comply with the Society of Automotive Engineers (SAE) recommended
practices prescribed in standards j599, j600, j1383 and j1735.
The seller makes no claims or warranties of any kind that the Symtech Corporation Optical Headlamp
Alignment Systems will align headlamps that do not conform to Society of Automotive Engineers recommended
practices described in j599, j600, j1383, and j1735.
Safety by Design