SINGER 321D-241M-24 INDUSTRIAL SERGER User Manual
321 d, 321 k, Instruction manual and parts list
Table of contents
Document Outline
- Contents
- 1 Safety Instructions
- 2 Product Description and Machine Specification
- 3 Setup and Adjustment Instructions
- 3.1Table Cut-OutDiagram
- 3.2 Machine Installation
- 3.3 Lubrication and OilDrainage
- 3.4 Fill Silicon Oil to Reservoir
- 3.5 Needle Attachment (or Replacement)
- 3.6 Replacing Upper and Lower Knife
- 3.7 MachineThreading
- 3.8 Thread Tension Adjustment
- 3.9 Presser foot pressure
- 3.10 Adjusting the Differential Feed Rate
- 3.11 Stitch Length Adjustment
- 3.12 Parts Relation and Timing
- 4 Maintenance
- 5 Troubleshooting
- 6 Parts list
- 6.1 Machine Bed Frame Components
- 6.2 Machine Cover Components (1)
- 6.3 Machine Cover Components (2)
- 6.4 Crank shaft Drive Components
- 6.5 Thread Tension Components
- 6.6 Thread Guide and Thread Take-up Components (1)
- 6.7 Thread Guide and Thread Take-up Components (2)
- 6.8 Thread Guide and Thread Take-up Components (3)
- 6.9 Needle Bar Components (1)
- 6.10 Needle Bar Components (2)
- 6.11 Needle Plate and Needle Guard Components
- 6.12 Upper Looper Components
- 6.13 Lower Looper Components
- 6.14 Chain Stitch Looper Components (1)
- 6.15 Chain Stitch Looper Components (2)
- 6.16 Differencial Feed Components
- 6.17 Feed Dog Components
- 6.18 Knife Drive Components
- 6.19 Presser Foot Components
- 6.20 Lubrication Components (1)
- 6.21 Lubrication Components (2)
- 6.22 Silicon Oil Reservoir Components
- 6.23 Exclusive Parts List for 321K series
- 6.24 Thread Stand Components
- 6.25 Accessories
- 6.26 Machine Support Plate For Semi-Submerged Components
- 6.27 Specific Parts for 321D-251 Hand 321K-251H
- 6.28 Optional Parts
- 6.29 Back Latch Components
- 6.30 Vacuum Suction & AFL Device (Option parts)
- ChainCutter DeviceComponents
- 7 Gauge Parts List