QOMO QD1600 - Manual (Page 17)

SWITCHABLE RGB INPUTS
Use the “CCD/PC1/PC2” button to switch between CCD and different RGB
signals. Each time the “CCD/PC1/PC2” button is pressed, it provides
seamless transitions among different sources such as Camera (CCD)、
COMPUTER(IN)、and RGB (IN).
Notes: RGB OUT always outputs RGB IN signals.
PROJECTOR ON/STANDBY
Press the “POWER” button to turn on the Visualizer’s power and press the
“Ppw” button to turn the projector power on. To turn the projector standby
after use, press the “Ppw” button more than 2 seconds, and then the
projector enters to the standby mode. (On the remote control, press the
“PROJECTOR POWER” button)
PROJECTOR INPUTS SELECTION
When the projector is connected to several input sources, use the “Pin”
button to switch signal inputs of the projector. (On the remote control, press
the “PROJECTOR INPUT” button)
IMAGE ROTATION
In order to rotate the image, press the “Rot” button once, the displayed
image will be rotated 90/180/270 degrees clockwise. Press the “Rot” button
again, the rotated image will be restored to the initial position.
IMAGE REVERSION
Press the “MIRROR” button once to mirror the image and the
vertically mirrored image will be displayed. Press the “MIRROR” button
again to exit.
INFRARED REMOTE CONTROL
The Visualizer’s remote control can control the camera from different
angels. Please note that an infrared remote control can only be used up to
17