Oldcastle BuildingEnvelope 6000 Series Thermal MultiPlane - Manual (Page 25)

24 


S E R I E S 6 0 0 0 T H E R M A L M U L T I P L A N E I N S T A L L A T I O N M A N U A L
FRAME INSTALLATION
FG-6188 PVC filler
may be used to improve
installation of perimeter
seals (optional)
FG-6430-01
head anchor
NOTES:
1. Anchor size and frequency should be determined by
structural requirements.
2. Sill and head anchors should be located so that the anchor is not more than 4" away from each side of
vertical mullion.
3. Assembly of frames without flashing is not recommended.
4. Assembly of frames using a non-thermal or sheet metal flashing will result in loss of thermal continuity and is
not recommended.
5. Do not anchor frame through the vertical leg of subsill.