Mercedes-Benz CL-Class 2008 COMAND Manual - Manual (Page 366)

365
Controls in detail
Starter switch positions
̄ Starter switch positions
SmartKey
Starter switch
0 For removing SmartKey
1 Power supply for some electrical con-
sumers
2 Ignition (power supply for all electrical
consumers) and driving position.
All lamps (except high beam headlamp
indicator lamp and turn signal indicator
lamps unless activated) in the instru-
ment cluster come on. If a lamp in the
instrument cluster fails to come on
when the ignition is switched on, have
it checked and replaced if necessary.
If a lamp in the instrument cluster re-
mains on after starting the engine or
comes on while driving, refer to “Lamps
in instrument cluster” (
୴ page 608).
3 Starting position
For information on starting the engine us-
ing the SmartKey, see “Starting with the
SmartKey” (
୴ page 407).
Warning!
G
When leaving the vehicle, always remove the
SmartKey or SmartKey with KEYLESS-GO*
from the starter switch, take it with you, and
lock the vehicle. Do not leave children unat-
tended in the vehicle, or with access to an
unlocked vehicle. A child’s unsupervised ac-
cess to a vehicle could result in an accident
and/or serious personal injury.
i When you switch on the ignition, the indica-
tor and warning lamps (except high beam head-
lamp indicator lamp and turn signal indicator
lamps unless activated) in the instrument cluster
come on. The indicator and warning lamps (ex-
cept high beam headlamp indicator lamp and
turn signal indicator lamps if activated) should go
out when the engine is running. This indicates
that the respective systems are operational.
! If you turn off the engine using the
SmartKey and
ț remove the SmartKey from the starter
switch
or
ț open a door
the transmission will shift to park position P
automatically.
Keep in mind that turning off the engine with the
SmartKey alone only will automatically shift the
transmission to neutral position N.
! If the SmartKey cannot be turned in the
starter switch, the battery may not be sufficient-
ly charged.
ț Check the battery and charge it if necessary
(
୴ page 702).
ț Have the vehicle jump-started ( ୴ page 707).
To prevent accelerated battery discharge or a
completely discharged battery, always remove
the SmartKey from the starter switch when the
engine is not in operation.