Mercedes-Benz CL-Class 2008 COMAND Manual - Manual (Page 206)

205
Control systems
COMAND navigation system (entering a destination)
List of cities with input characters
When this list appears, the input charac-
ters
4 are automatically activated.
1 Top list entry based on the input data
up to that point
2 Characters entered by the user
3 Characters automatically added by the
system
4 Input characters
5 Currently non-selectable characters
6 Currently selectable character
7 List of cities
8 Currently selected character
The top list entry 1 at first shows either
the city in which the vehicle is currently lo-
cated or the city which best corresponds
to the input data as it has been entered up
to that point.
As soon as you enter a character from in-
put characters
4, the top list entry 1
shows the city that best corresponds to
the input data as it has been entered up to
that point.
At the same time, COMAND automatically
supplements characters
2 entered by the
user with appropriate characters 3.
̈ Selecting characters: Slide o m p or
rotate y m z .
̈ Confirming character selection:
Press
n.
̈ Deleting individual characters:
Select
) in the bottom line and
press n.
̈ Deleting an entire entry: Select ) in
the bottom line and press n until the
entire entry is deleted.
̈ Canceling an entry: Select “Back” in
the bottom line and press
n.
or
̈ Press back button L in the center
console ( ୴ page 84).
i In the list of input characters 4, you can
only select currently selectable characters.
Which characters are included depends on the
sequence in which you have entered your desti-
nation and the data version of the digital map.
i The current city is shown if:
ț you have accepted the current state (USA) or
province (CDN) when entering the state
(USA) or province (CDN)
ț and if you select city entry immediately after-
ward