Mercedes-Benz CL-Class 2008 COMAND Manual - Manual (Page 223)

222
Control systems
COMAND navigation system (entering a destination)
Moving the map and selecting the des-
tination
̈ Moving map: Slide q m r , o m p or
w m x .
̈ Adjusting map scale: Rotate y m z .
Rotating clockwise enlarges the map,
rotating counterclockwise reduces it.
̈ Selecting a destination: Press n.
If the crosshair is located off the edge
of the digital map, a route cannot be
calculated to this destination and you
will see the message “The destination is
located off the map.”.
̈ Select “OK”.
̈ Move the map and select a destination
again.
If the destination is within the limits of
the digital map, COMAND attempts to
attribute the destination to the map,
which can take approximately
2 seconds.
If the destination can be attributed, you
will see the address of the destination.
If not, you will see the display “Destina-
tion from map”.
̈ Starting route calculation:
Select “Start”, see also (
୴ page 218).
Entering a stopover
i When route guidance is active, you can en-
ter a stopover. Stopovers can be predefined des-
tinations from the following predefined
categories:
ț “Mercedes-Benz Center”
ț “Hospital”
ț “Gas station”
ț “Parking lot”
ț “Restaurant”
However, you can also enter destinations other
than the predefined ones.
i You can use the stopover function to influ-
ence the route guidance calculation to the main
destination. When you have reached your stop-
over, COMAND automatically calculates the
route to the main destination.