Mercedes-Benz G-Class 2011 Owners Manual - Manual (Page 297)

: Lug wrench
;
Electric air pump
= Instructions on the installation position of
the vehicle tool kit holder
?
Fuse allocation chart
A Alignment bolt
B
Folding wheel chock
C Towing eye
D
Wheel bolts
E Stowage well
F
Ratchet ring spanner
G Jack
Collapsible spare wheel
Removing the collapsible spare wheel
The collapsible spare wheel can be found in
the stowage well under the cargo
compartment floor.
X Lift the cargo compartment floor up
(
Y page 294).
X Remove the jack from the tool holder
(
Y page 294).
X Turn retaining screw : counter-clockwise
and out of tool holder = and remove it.
i If retaining screw : does not come out
immediately, turn tool holder = slightly
counter-clockwise.
Retaining screw : can then be unscrewed
with ease.
X Turn tool holder = approximately 180°, so
that the electric air pump points
backwards.
X Remove tool holder = from collapsible
spare wheel ;.
X Remove collapsible spare wheel ; from
the emergency spare wheel well.
For further information on changing a wheel
and mounting the spare wheel, see
(
Y page 301).
Stowing a used collapsible spare wheel
Take the following steps to stow a used
collapsible spare wheel. It will otherwise not
fit in the spare wheel well. Mercedes-Benz
recommends that you have this work carried
out at a qualified specialist workshop, e.g. an
authorized Mercedes-Benz Center.
! Only place the collapsible spare wheel in
the vehicle when it is dry. Otherwise,
moisture may get into the vehicle.
X Unscrew the valve cap from the valve.
X If possible, unscrew the valve insert from
the valve and release the air.
Where will I find...?
295
Roadside Assistance
BA 251 USA, CA Edition A 2011; 1; 3, en-US
d2sboike
Version: 3.0.3.5
2010-04-16T14:31:55+02:00 - Seite 295
Z