Mercedes-Benz CLA-Class 2015 - Manual (Page 355)

Vehicle identification number (VIN)
X Slide the right-hand front seat to its rear-
most position.
X
Fold floor covering : upwards.
You will see VIN ;.
The VIN can also be found on the vehicle
identification plate (
Y
page 352).
The VIN can also be found at the lower edge of
the windshield (
Y
page 353).
Engine number
: Emission control information plate,
including the certification of both federal
and Californian emissions standards
; VIN (on the lower edge of the windshield)
= Engine number (stamped into the crank-
case)
Service products and filling capaci-
ties
Important safety notes
G WARNING
Service products may be poisonous and haz-
ardous to health. There is a risk of injury.
Comply with instructions on the use, storage
and disposal of service products on the labels
of the respective original containers. Always
store service products sealed in their original
containers. Always keep service products out
of the reach of children.
H Environmental note
Dispose of service products in an environ-
mentally responsible manner.
Service products include the following:
R
Fuels
R Lubricants (e.g. engine oil, transmission oil)
R Coolant
R Brake fluid
R Windshield washer fluid
R
Climate control system refrigerant
Components and service products must be
matched. Only use products recommended
by Mercedes-Benz. Damage which is caused
by the use of products which have not been
recommended is not covered by the
Mercedes-Benz warranty or goodwill ges-
tures. They are listed in this Mercedes-Benz
Operator's Manual in the appropriate section.
Information on tested and approved products
can be obtained at an authorized Mercedes-
Benz Center or on the Internet at
http://bevo.mercedes-benz.com.
You can recognize service products approved
by Mercedes-Benz by the following inscrip-
tion on the containers:
R MB-Freigabe (e.g. MB-Freigabe 229.51)
R
MB Approval (e.g. MB Approval 229.51)
Other designations or recommendations indi-
cate a level of quality or a specification in
Service products and filling capacities
353
Tec
hni
ca
ldata
Z