Losi LOSB0126 User Manual
Getting started

1
1) Install the 4 AA-sized alkaline batteries in the
transmitter making sure the positive (+) and
(-) negative ends are oriented correctly.
2) Remove the wires from the clips on the top
of the battery box cover. Depress the lever on
the front half of the plug and unplug the two
halves.
3) Remove the two wire clips holding the top on
the battery box and remove the battery pack.
Plug the included AC charger into an outlet.
Plug the battery pack into the charger noting
that it can only be plugged in one way. The
light on the charger will glow RED until the
battery is charged at which time it will glow
GREEN.
NOTE: Before you start running your Ten-T, you MUST read the
operating and engine tuning instructions. Failure to do
so will cause you to not get maximum performance from
your engine, and possibly void the warranty.
GETTING STARTED
GETTING STARTED
NOTE:
Before you start running your LST XXL™, read your engine break-in and operating
instructions. If you run your LST XXL without following proper break-in procedure,
you may damage or fail to get maximum performance from your engine, and void the
warranty.