Losi LOSB0013 Getting Started Guide - Manual (Page 3)

Page
After filling the fuel bottle with fuel, lift the lid of the fuel tank and fill the tank (fig.8A). Make sure you put the lid back on both
the fuel bottle and the jug of fuel. Press down on the primer button several times (fig.8B) until you see the fuel move through
the fuel line to the carburetor. Do not pump the primer after the fuel reaches the carburetor or you will flood the engine and
make it difficult to start.
Attach the glow plug ignitor (Fig. 9A) to the glow plug. Put the standard hex of the starter shaft into the Spin-Start. Slide your
hand under the strap of the starter so that your index finger is on the switch at the bottom. Place the machined end of the
starter shaft into the matching hex socket in the back-plate of the engine (Fig. 9B). Holding the starter securely, press on the
switch button and the engine should turn over and start up. If the engine does not turn over, it is probably flooded or the
battery in the starter needs to be recharged. Use a glow plug wrench to loosen the glow plug at least two turns and try again.
Raw fuel should come out around the plug. Tighten the plug and resume the starting procedure.
Follow the engine break-in procedure before attempting any racing or high-performance operation. Use caution when adding
fuel while the engine is running. Do not over fill or spill fuel outside the tank.
8A 8B
Fueling
Start Your Engine
9A 9B