Kontron KTT20-pITX - Manual (Page 28)

KTD-S0045-D Page 24 Bootloader Modification and Download
KTT20/pITX Software Guide
S
Execute the 'ktt20.sh' file. The following screen output must appear:
Nvflash started
rcm version 0X20001
System Information:
chip name: t20
chip id: 0x20 major: 1 minor: 3
chip sku: 0x8
chip uid: ........
macrovision: disabled
hdcp: enabled
sbk burned: false
dk burned: false
boot device: spi
operating mode: 3
device config strap: 0
device config fuse: 0
sdram config strap: 0
sending file: KTT20.bct
4080/4080 bytes sent
KTT20.bct sent successfully
downloading bootloader -- load address: 0x108000 entry point: 0x108000
sending file: u-boot.bin
..... / ..... bytes sent
u-boot.bin sent successfully
waiting for bootloader to initialize
bootloader failed NvError 0x0
command failure: bootloader download failed
S
Ignore the error messages. The 'nvflash' program expects some additional operations which
are never executed. Now U-Boot is starting and you should see the bootloader serial output
on your terminal program.
† Download the bootloader into SPI TM flash
S
If you want to flash a new final bootloader version or to repair a damaged bootloader use
the script file from the directory 'SPI'. An important prerequisite is an existing image file as
output from the 'ImageCreator' tool (default name: spi-flasher.img) or from a Kontron BSP.
Copy your image file, the file from the directory 'SPI' and all files from the NVFLASH root
directory into the same directory.