Kontron KTT20-pITX - Manual (Page 24)

KTD-S0045-D Page 20 Bootloader Modification and Download
KTT20/pITX Software Guide
CAUTION
KONTRON does not repair a board free of charge if the
SPI
TM
flash respectively SDRAM parameters are changed.
The third component implies your own bootloader. Maybe in the ASCII equivalent of the Binary Configu-
ration Table the line labeled
BootLoader must be changed. The line arguments are defined as follows:
bootloader = , , , Complete
The string Complete is a fixed designator (not changeable) but the arguments load address and entry point
are bootloader specific. Normally for U-Boot bootloaders both parameters corresponds with the value
0x00108000.
The KONTRON Image Creator package includes the following files:
S
IMAGECREATOR.EXE main program
S
CONVERT.EXE 32 bit console program (conversion utility)
S
SPI-FLASHER.BIN special U-Boot version
S
SPI.CFG ASCII equivalent for the Binary Configuration Table
Additional needed file:
S
Your own bootloader the file name must be identical with
NOTICE: Do not use a 64 bit Windows ® environment, the package runs only with Windows ® XP and 32 bit
Windows ® 7.
5.1 Program IMAGECREATOR
After the program start you see the following screen
The Create button generates the required image. The first step loads the ASCII equivalent for the Binary
Configuration Table (e.g. SPI.CFG) which includes the name of your own bootloader. This bootloader must
exist in the same directory as the main program. The second step loads the SPI-FLASHER program and
combines it with the Binary Configuration Table (now a really binary module) and your own bootloader.