Kontron CP305 BIOS - Manual (Page 68)

Boot Setup CP305 BIOS
Page 58 ID 1035-8356, Rev. 1.0
P R E L I M I N A R Y
Wait for ‘F1’ If Error SDO
This function is used to allow the Wait for ‘F1’ Error setting to be modified.
Optimal and Fail-Safe default settings: Disabled
Hit ‘DEL’ Message Display
This function is used to allow the Hit ‘DEL’ to enter Setup Message Display to be modified.
Optimal and Fail-Safe default settings: Enabled
Interrupt 19 Capture
This function is used to allow option ROMs such as network controllers to trap BIOS interrupt 19.
Optimal and Fail-Safe default settings: Disabled
Retry Boot Sequence SDO
This function is used to specify how the system is to respond to a boot error.
Optimal and Fail-Safe default settings: Enabled
SETTING DESCRIPTION
Disabled Use this setting to prevent the CP305 from waiting on an error for user intervention. If this
setting is used, the system will continue to boot up the operating system. If ‘F1’ is enabled,
the system will wait until the BIOS setup is entered.
This setting should be used if there is a known reason for a BIOS error to occur. An exam-
ple would be a system administrator must remote boot the system. The computer system
does not have a keyboard currently attached.
Enabled Use this setting to allow the BIOS to wait for any error. If an error is detected, pressing
will enter Setup and the BIOS setting can be adjusted to fix the problem. This nor-
mally happens when upgrading the hardware and not setting the BIOS to recognize it.
SETTING DESCRIPTION
Disabled Use this setting to prevent the display of the message
Hit Del to enter Setup
during memory initialization.
If Quiet Boot is enabled, the Hit ‘DEL’ message will not be displayed.
Enabled Use this setting to allow the display of the message
Hit Del to enter Setup
during memory initialization.
SETTING DESCRIPTION
Disabled Use this setting to prevent option ROMs from trapping interrupt 19.
Enabled Use this setting to allow option ROMs to trap interrupt 19.
SETTING DESCRIPTION
Disabled Use this setting to finish booting and show error message in case of boot failure.
Enabled Use this setting to specify that booting should be attempted again until a boot device is
found. To interrupt retrying, the system must be reset.
Use this setting when booting from a network drive.