Kontron CP305 BIOS - Manual (Page 51)

CP305 BIOS Advanced Setup
ID 1035-8356, Rev. 1.0 Page 41
P R E L I M I N A R Y
Terminal Type SDO
This function is used to select the target terminal type.
Note: This function is only available when the Remote Access function is set to Enabled.
Optimal and Fail-Safe default settings: ANSI
VT-UTF8 Combo Key Support
This function is used to enable or disable the VT-UTF8 combo key support.
Note: This function is only available when the Remote Access function is set to Enabled.
Optimal and Fail-Safe default settings: Enabled
Sredir Memory Display Delay
This function is used to select the time during which the serial redirection memory usage infor-
mation is displayed on the serial console at start of POST.
Note: This function is only available when the Remote Access function is set to Enabled.
Optimal and Fail-Safe default settings: No Delay
EMS Support (SPCR)
This function is used to enable the EMS (Emergency Management Services) support via the
ACPI SPCR (Serial Port Console Redirection) table if console redirection is enabled.
Note: This function is only available when the Remote Access function is set to Enabled.
Optimal and Fail-Safe default settings: Disabled
SETTING DESCRIPTION
ANSI Use this setting to specify that the target terminal type is ANSI.
VT100 Use this setting to specify that the target terminal type is VT100.
VT-UTF8 Use this setting to specify that the target terminal type is VT-UTF8.
SETTING DESCRIPTION
Disabled Use this setting to disable the VT-UTF8 combination key support for the ANSI/VT100 terminals.
Enabled Use this setting to enable the VT-UTF8 combination key support for the ANSI/VT100 terminals.
SETTING DESCRIPTION
No Delay Use this setting to specify that the memory display does not pause during redirection.
Delay 1 sec Use this setting to set the delay to display memory information to one second.
Delay 2 sec Use this setting to set the delay to display memory information to two seconds.
Delay 4 sec Use this setting to set the delay to display memory information to four seconds.
SETTING DESCRIPTION
Disabled Use this setting to prevent the system from filling the SPCR table. No EMS will be available.
Enabled Use this setting to fill the SPCR table if console redirection is enabled. EMS will be available.