Kontron MSM800SEL - Manual (Page 18)

MSM800SEV/SEL / Specifications
www.kontron.com 16
Video
Controller MSM800SEV/SEL
Bus 32bit high speed 33MHz PCI bus
Enhanced BIOS VGA/LCD BIOS
Memory 2-254MByte shared RAM
CRT-Monitor VGA, SVGA up to 1920x1440
Flat Panel TFT 3.3V 18/24bit up to 1600x1200
Controller Modes CRT only; flat panel only; or simultaneous CRT and flat panel
Video Input No
Drivers WIN2000, XP
Mass Storage
FD Floppy disk interface, for max. 1 floppy with 26pin connector
HD
E-IDE interface, AT-type, for max. 2 hard disks, 44pin connector, for 1.3, 1.8 and 2.5" hard
disks with 44 pins IDE
Standard AT Interfaces
Name FIFO IRQs Address Standard Option
COM1
COM2 yes
yes IRQ4
IRQ3 3F8
2F8 RS232C
RS232C
Serial
(Baud rates: 50-115 KBaud programmable)
Parallel LPT1 printer interface mode: SPP(output), EPP (bidirectional) (Centronics)
Keyboard AT or PS/2 –keyboard
Mouse PS/2
Speaker 0.1 W output drive
RTC Integrated into the chipset, RTC with CMOS-RAM 256Byte
Backup Current <5 µA
Non-chargeable Battery
MSM800SEV: 3.6V lithium 400mAh internally or externally connected
MSM800SEL: External 3.6V lithium battery needed
Bus
PC/104 ISA
IEEE-996 standard ISA bus, buffered
MSM800SEV/SEL:
8bit and limited 16bit support DMA only
Clock 8MHz defined by the Geode
USB
USB 2.0
Transfer Rate 400MBps, 12.5MBps/1.5MBps
Channels 4
Peripheral Extension
ISA
With PC/104 bus
MSM800SEV/SEL:
with ISA 8bit or 16bit DMA only
PCI
With PC/104-Plus bus
MSM800SEV/SEL:
4 slots – max. 3 master devices