Kontron AM4022 - Manual (Page 30)

Introduction AM4022
Page 1 - 12 ID 1052-0183, Rev. 1.0
Thermal
Thermal Management CPU and board overtemperature protection is provided by:
• Up to four Digital Thermal Sensors (DTS), one for each core
• One Digital Thermal Sensor (DTS) for the graphics controller
• Catastrophic Cooling Failure Sensor (THERMTRIP#)
• One temperature sensor integrated in the Intel® QM77 chipset for
monitoring the chipset
• One onboard temperature sensor for monitoring the board temperature
• Specially designed heat sinks
Se
cu
rit
y TPM Trusted Platform Module (TPM) 1.2 for enhanced hardware- and software-
based data and system security (on request)
General
Power Consumption Refer to Chapter 5, “Power Considerations” for information related to the
power consumption of the AM4022.
Temperature Range Operational: -5°C to +55°C Standard
-40°C to +70°C Extended (on request)
Storage: -40°C to +70°C
RTC Backup Battery
Module (on request) Special battery mezzanine module with up to two batteries connected in paral-
lel; uses the J7 connector for interfacing with the AM4022
If this module is installed, the SATA Flash module cannot be installed.
Temperature ranges:
Operational: -
5°C to + 55°C
Storage: -30°C to + 60°C
Mechanical Single Module:
• Mid-size version
• Full-size version
Both versions available with and without retaining screws
Table 1-2: AM4022 Main Specifications (Continued)
AM4022 SPECIFICATIONS
Note ...
When the RTC Backup Battery Module is installed, refer to
the operational specifications of this module as this deter-
mines the storage temperature of the AM4022 (See "RTC
Backup Battery Module" below).
Note ...
When additional components are installed, refer to their opera-
tional specifications as this will influence the operational and stor-
age temperature of the AM4022.