Kontron VMP2 - Manual (Page 5)

VMP2 Preface
ID 24855, Rev. 02 Page 0 - 5 © 2002 PEP Modular Computers GmbH
Chapter
4
4. Configuration ................................................................................................ 4 - 3
4.1 Jumper Settings ..................................................................................... 4 - 3
4.1.1 Bootstrap Loader / Socket Jumper J1 .............................................. 4 - 3
4.1.2 RTC (Real-time clock) Calibration Output (J2) ................................ 4 - 3
4.1.3 Resistor Setting for Non-standard Socket Devices .......................... 4 - 4
4.1.4 RS485 Termination (Onboard Interface Only) ................................. 4 - 4
4.2 Pinouts ................................................................................................... 4 - 5
4.2.1 Flash Socket Type Selection ........................................................... 4 - 5
4.2.1.1 Socket Device Selection (Memory Expansion Socket IC8) ........ 4 - 5
4.2.2 Serial Interface Expansion Connector (CON3) ................................ 4 - 6
4.3 Board Address Map ............................................................................... 4 - 7
4.3.1 Address Map Overview .................................................................... 4 - 7
4.3.2 VME Address Area .......................................................................... 4 - 8
4.3.3 Onboard Device Addresses ............................................................. 4 - 9
4.3.4 Special Registers Overview ........................................................... 4 - 10
4.3.4.1 Board Control Registers ........................................................... 4 - 10
4.3.4.2 Board ID Register ..................................................................... 4 - 10
4.3.4.3 Software Compatibility ID ......................................................... 4 - 11
4.3.4.4 Memory Configuration Register ............................................... 4 - 12
4.3.4.5 Flash Bank Select Register ...................................................... 4 - 12
4.3.4.6 Watchdog Control Register ...................................................... 4 - 13
4.3.4.7 Control Register ....................................................................... 4 - 14
4.3.4.8 Event Register .......................................................................... 4 - 15
4.3.4.9 Board / Logic Revision Register ............................................... 4 - 16
4.3.4.10 UART A / Registers ................................................................ 4 - 17
4.3.4.11 UART B / Registers ................................................................ 4 - 18
4.3.5 IRQ Routing ................................................................................... 4 - 19
4.3.6 Real-time Clock .............................................................................. 4 - 20
4.3.7 EEPROM ....................................................................................... 4 - 21
4.3.8 Digital Temperature Sensor ........................................................... 4 - 21