Pb-dout8, Introduction, 4 board layout – Kontron PB-DOUT8 User Manual
Page 15

PB-DOUT8
22 Oct 98
Introduction
Page 1 - 5
Man. ID 17984, Rev. Index 0110
1.3.2
Low-Side Power Switches
The PB-DOUT8 module is provided with four two-channel Siemens TLE 5224 G2 smart
power transistors for low-side switching having the following features:
•
overload protection
•
power limitation
•
short-circuit protection
•
overtemperature monitoring
•
overvoltage protection
•
ESD protection
1.3.3
Board Interfaces
The PB-DOUT8 piggyback module is provided with two digital I/O connectors. The one
on the input side is a 15-pin double-row connector, the one on the process side a 12-pin
double-row connector. The input connector is wired via the carrier board to a 50-pin
DSUB or to a 50-pin FB connector, while the process interface is wired to the carrier
board’s VMEbus socket.
1.4 Board Layout
Figure 1-2: PB-DOUT8 Board Layout — Component Side (Left) and Solder Side (Right)
!
Attention!
In fitting your PB-DOUT8 piggyback module onto its carrier board,
please make sure the PB-DOUT8 pin rows match the correspond-
ing rows of pinholes of the carrier board socket (see chapter 3).
LOGIC
O
P
T
O
-C
O
U
P
L
E
R
S
High-side
Power
Switches
S
T
2
1
30
S
T
1
24
1
Low-side
Power
Switches
(NSR)
Legend:
NSR = Not system-relevant