Park/headlight on indicator, Vehicle security light, Electronic speed control on indicator – Jeep 2015 Grand Cherokee SRT - User Guide User Manual
Page 197: Electronic speed control set indicator, Hill descent control indicator — if equipped, Door ajar indicator, Windshield washer fluid low indicator, Liftgate ajar indicator — if equipped, Engine oil life reset, What to do in emergencies
- Park/Headlight ON Indicator
This indicator will illuminate when the park lights or headlights are turned on.
- Vehicle Security Light
This light will flash rapidly for approximately 15 seconds when the vehicle security
alarm is arming. The light will flash at a slower speed continuously after the alarm is
set. The security light will also come on for about three seconds when the ignition is
first turned on.
- Electronic Speed Control ON Indicator
This indicator will illuminate when the electronic speed control has been activated to
the “ON” position.
- Electronic Speed Control SET Indicator
This indicator will illuminate when the cruising speed has been set.
- Hill Descent Control Indicator — If Equipped
This indicator will illuminate when Hill Descent Control (HDC) has been selected
using the Hill Descent Control Switch.
- Door Ajar Indicator
This indicator will illuminate when a door(s) is left ajar and not fully closed.
- Electronic Stability Control (ESC) OFF Indicator Light
This light indicates the Electronic Stability Control (ESC) is off.
- Windshield Washer Fluid Low Indicator
This indicator will illuminate when the windshield washer fluid is low.
- Liftgate Ajar Indicator — If Equipped
This indicator will illuminate when the liftgate is left ajar and not fully closed.
Engine Oil Life Reset
Oil Change Required
Your vehicle is equipped with an engine oil change indicator system. The “Oil Change
Required” message will display in the DID for five seconds after a single chime has
sounded, to indicate the next scheduled oil change interval. The engine oil change
indicator system is duty cycle based, which means the engine oil change interval may
fluctuate, dependent upon your personal driving style.
Unless reset, this message will continue to display each time you turn the ignition
switch to the ON/RUN position or cycle the ignition to the ON/RUN position if
equipped with Keyless Enter-N-Go™. To turn off the message temporarily, press and
release the OK button. To reset the oil change indicator system (after performing the
scheduled maintenance) refer to the following procedure.
WHAT TO DO IN EMERGENCIES
195