beautypg.com

Quadra-lift™ — if equipped, When to use 4wd low range — if equipped, When to use 4wd low range — if – Jeep 2015 Grand Cherokee - Owner Manual User Manual

Page 459: Equipped

background image

NOTE:

• It may be necessary to apply additional force to

individual tabs to make sure they are fully engaged.

• Do not use any tools to apply additional force to the

tabs as damage to the upper and lower fascias may

result.

4. Reinstall the seven quarter turn fasteners.

Quadra-Lift™ — If Equipped

When off-roading, it is recommended that the lowest

useable vehicle height that will clear the current obstacle

or terrain be selected. The vehicle height should then be

raised as required by the changes in terrain.
The Selec-Terrain™ switch will automatically change the

vehicle to the optimized height based on the Selec-

Terrain™ switch position. The vehicle height can be

changed from the default height for each Selec-Terrain™

mode by normal use of the air suspension switches. Refer

to “Quadra-Lift™ – If Equipped” in “Starting and Oper-

ating” for further information.

When To Use 4WD LOW Range — If Equipped

When off-road driving, shift to 4WD LOW for additional

traction. This range should be limited to extreme situa-

tions such as deep snow, mud, or sand where additional

low speed pulling power is needed. Vehicle speeds in

excess of 25 mph (40 km/h) should be avoided when in

4WD LOW range.

CAUTION!

Do not drive in 4WD-LOW Range on dry pavement;
driveline damage may result. 4WD-LOW Range
locks front and rear drivelines together and does not
allow for differential action between the front to rear

(Continued)

5

STARTING AND OPERATING 457