Jeep 2015 Grand Cherokee - Owner Manual - Manual (Page 238)

Service The ParkSense® Park Assist System
During vehicle start up, when the ParkSense® System
has detected a faulted condition, the instrument cluster
will actuate a single chime, once per ignition cycle, and it
will display the ЉPARKSENSE UNAVAILABLE WIPE
REAR SENSORSЉ, ЉPARKSENSE UNAVAILABLE WIPE
FRONT SENSORSЉ, or the ЉPARKSENSE UNAVAIL-
ABLE SERVICE REQUIREDЉ message for five seconds.
When the shift lever/gear selector is moved to Reverse
and the system has detected a faulted condition, the
Driver Information Display (DID) will display a
Љ
PARKSENSE UNAVAILABLE WIPE REAR SENSORSЉ,
Љ PARKSENSE UNAVAILABLE WIPE FRONT SENSORSЉ
or ЉPARKSENSE UNAVAILABLE SERVICE REQUIREDЉ
pop up message for five seconds. After five seconds, a car
graphic will be displayed with ЉUNAVAILABLEЉ at ei-
ther the front or rear sensor location depending on where
the fault is detected. The system will continue to provide
arc alerts for the side that is functioning properly. These
arc alerts will interrupt the ЉPARKSENSE UNAVAIL-
ABLE WIPE REAR SENSORSЉ, ЉPARKSENSE UNAVAIL-
ABLE WIPE FRONT SENSORSЉ, or ЉPARKSENSE UN-
AVAILABLE SERVICE REQUIREDЉ messages if an object
is detected within the five second pop-up duration. The
car graphic will remain displayed for as long as the
vehicle is in REVERSE. Refer to “Driver Information
Display (DID)” for further information.
If ЉPARKSENSE UNAVAILABLE WIPE REAR SENSORSЉ
or ЉPARKSENSE UNAVAILABLE WIPE FRONT SEN-
SORSЉ appears in the Driver Information Display (DID)
make sure the outer surface and the underside of the rear
fascia/bumper and/or front fascia/bumper is clean and
clear of snow, ice, mud, dirt or other obstruction and then
cycle the ignition. If the message continues to appear see
an authorized dealer.
If the ЉPARKSENSE UNAVAILABLE SERVICE RE-
QUIREDЉ message appears in the DID, see an authorized
dealer.
236 UNDERSTANDING THE FEATURES OF YOUR VEHICLE