Jeep 2013 Grand Cherokee - User Guide - Manual (Page 41)

BLIND SPOT MONITORING
• The Blind Spot Monitoring (BSM) system uses two radar-based sensors, located
inside the rear bumper fascia, to detect Highway licensable vehicles (automobiles,
trucks, motorcycles etc.) that enter the blind spot zones from the rear/front/side of
the vehicle.
• The Blind Spot Monitoring (BSM) system warning light, located in the outside
mirrors, will illuminate if a vehicle moves into a blind spot zone.
• The BSM system can also be configured to sound an audible (chime) alert and
mute the radio to notify you of objects that have entered the detection zones.
• Refer to your owner's manual on the DVD for further details.
LIFTGATE FLIPPER GLASS
• The liftgate flipper glass is unlocked
when the liftgate is unlocked. To open
the flipper glass, push up on the win-
dow switch located on the liftgate.
When flipper glass is unlatched it will
not completely raise, lift up on flipper
glass handle to open.
NOTE:
If a malfunction to the liftgate latch
should occur, an emergency liftgate latch
release, located on the inside of the ve-
hicle, can be used to open the liftgate.
The emergency liftgate latch release can
be accessed through a snap-in cover lo-
cated on the liftgate trim panel.
WARNING!
• Driving with the liftgate or flipper glass open can allow poisonous exhaust
gases into your vehicle. You and your passengers could be injured by these
fumes. Keep the flipper glass closed when you are operating the vehicle.
• To avoid injury, stand back when opening. Glass may automatically rise.
OPERATING YOUR VEHICLE
39