Jeep 2013 Grand Cherokee - User Guide - Manual (Page 17)

Removing The Button
• The ENGINE START/STOP button can
be removed from the ignition switch for
Key Fob use.
• Insert the metal part of the emergency
key under the chrome bezel at the
6 o’clock position and gently pry the
button loose.
NOTE:
The ENGINE START/STOP button should
only be removed or inserted with the
ignition in the LOCK position (OFF posi-
tion for Keyless Enter-N-Go™).
Engine Starting/Stopping
Starting
• With a valid Keyless Enter-N-Go™ Key
Fob inside the vehicle.
• Place the shift lever in PARK or NEU-
TRAL.
• While pressing the brake pedal, press
the ENGINE START/STOP button
once. If the engine fails to start, the
starter will disengage automatically
after 10 seconds.
• To stop the cranking of the engine
prior to the engine starting, press the
button again.
Stopping
• Place the shift lever in PARK.
• Press the ENGINE START/STOP button once. The ignition switch will return to the
OFF position.
• If the shift lever is not in PARK, the ENGINE START/STOP button must be held for two
seconds and vehicle speed must be above 5 mph (8 km/h) before the engine will shut off.
GETTING STARTED
15