Jeep 2013 Grand Cherokee - User Guide - Manual (Page 24)

• To program a Key Fob to the memory position, place the ignition switch in the
LOCK position and remove the Key Fob, press and release the LOCK button on the
Key Fob to be programmed within 5 seconds of pressing button 1 or 2.
• Place the ignition switch in the ON/RUN position, select Remote Linked to
Memory in the Electronic Vehicle Information Center (EVIC) and enter Yes.
• Press 1 or 2 to recall the saved positions, or press UNLOCK on the programmed
Key Fob.
• Refer to the Owner's Manual on the DVD for further details.
MANUAL SEAT
Forward/Rearward
• Lift up on the adjusting bar located at
the front of the seat near the floor and
release when seat is in desired posi-
tion. Then using body pressure move
forward or backward on the seat to be
sure that the seat adjusters have
latched.
Recliner
• Lift the rear lever located on the out-
board side of the seat, lean back and
release when seat is in desired position.
GETTING STARTED
22