beautypg.com

Turn signal/wiper/washer/high beam lever, Turn signal/lane change assist, Front wipers – Jeep 2013 Grand Cherokee - User Guide User Manual

Page 32: Operating your vehicle

background image

TURN SIGNAL/WIPER/WASHER/HIGH BEAM LEVER

Turn Signal/Lane Change Assist

• Tap the lever up or down once and the turn signal (right or left) will flash three times

and automatically turn off.

Front Wipers

Intermittent, Low And High Operation

• Rotate the end of the lever to the first detent position for one of four intermittent

settings, the second detent for low wiper operation and the third detent for high wiper
operation.

Washer Operation

• Push inward on the end of the lever and hold for as long as spray is desired.

Mist

• Rotate the end of the lever downward when a single wipe is desired.

NOTE:
The mist feature does not activate the washer pump; therefore, no washer fluid will
be sprayed on the windshield. The wash function must be activated in order to spray
the windshield with washer fluid.

Rain Sensing Wipers

• This feature senses moisture on the vehicles windshield and automatically

activates the wipers for the driver when the switch is in the intermittent position.
Rotate the end of the lever to one of four settings to activate this feature and adjust
sensitivity.

• This feature can be activated/deactivated using the Electronic Vehicle Information

Center (EVIC). Refer to the Programmable Features under the Electronics section
in this guide.

• Refer to the Owner's Manual on the DVD for further details.

OPERATING YOUR VEHICLE

30

This manual is related to the following products: