beautypg.com

Turn signals, Lane change assist, Daytime running lights - if equipped – Jeep 2009 Wrangler Unlimited - Owner Manual User Manual

Page 98: Interior lights, Daytime running lights — if equipped

background image

Turn Signals

Move the multifunction lever up or down, and the
arrows on each side of the instrument cluster flash, to
show proper operation of the front and rear turn signal
lights.

If either light has a very fast flash rate, check for a
defective outside light bulb. If an indicator fails to light
when the lever is moved, it would suggest that the fuse
or indicator is defective or there may be a circuit failure.

NOTE:

A tone will chime if the turn signals are left on

for more than 1 mile (2 km).

Lane Change Assist

Tap the lever up or down once without moving beyond
the detent and the turn signal (right or left) will flash
three times the automatically turn off.

Daytime Running Lights — If Equipped

The headlights come on at a low intensity level after the
vehicle has been driven approximately 3 ft (1 m). They
will turn off when the vehicle is turned off or when the
headlights are switched on.

Interior Lights

The overhead light will come on when a door is opened.
It may also be turned on by rotating the control for the
dimmer switch on the multifunction lever fully upward.

The overhead light will automatically turn off in approxi-
mately 20 minutes if a door is left open or the dimmer
control is left in the dome light position. Turn the ignition
switch ON to restore the overhead light operation.

Cargo Lamp
The courtesy and dome lights will turn on when the front
doors are opened, when the dimmer control (rotating
wheel on the right side of the switch) is rotated to the

96

UNDERSTANDING THE FEATURES OF YOUR VEHICLE