Jeep 2008 Liberty - Manual (Page 298)

original position, make certain all shift requirements
have been met, wait five (5) seconds, and try the shift
again.
• The ignition switch must be in the ON position for a
shift to take place and for the position indicator lights
to be operable. If the ignition switch is not in the ON
position, then the shift will not take place and no
position indicator lights will be on or flashing.
MP3022 Selec-Trac II
ா
Transfer Case — If
Equipped
Operating Information & Precautions
The Selec-Trac II
௡ active on-demand transfer case pro-
vides four positions:
• 2 (rear) wheel drive high range.
• 4-wheel drive auto high range.
• Neutral.
• 4-wheel drive low range.
This transfer case is intended to be driven in either the
2-wheel drive position (2WD) or the 4-wheel drive Auto
position (4WD Auto) for normal street and highway
conditions such as dry hard surfaced roads.
For added capability when traversing steep grades,
rough terrain, or extremely poor traction surfaces, select
the transfer case 4WD Low position. This position locks
the front driveshaft and rear driveshaft together and
forces the front and rear wheels to rotate at the same
speed while multiplying engine torque.
Use the transfer case Neutral (N) position for recreational
towing only. Refer to “Recreational Towing” in this
section for specific procedures on shifting into and out of
Neutral (N).
298 STARTING AND OPERATING