Jeep 2008 Liberty - Manual (Page 148)

WARNING!
Leaving the Electronic Speed Control system on
when not in use is dangerous. You could accidentally
set the system or cause it to go faster than you want.
You could lose control and have an accident. Always
leave the system OFF when you are not using it.
To Set At A Desired Speed:
When the vehicle reaches the speed desired, press down
on the lever and release (“SET DECEL”). Release the
accelerator and the vehicle will operate at the selected
speed.
NOTE:
• The vehicle must be traveling at least 25 mph (40
km/h) for the speed control to set.
• The vehicle should be traveling at a steady speed and
on level ground before pressing the lever (“SET DE-
CEL”).
To Deactivate:
A soft tap on the brake pedal, or pulling the speed control
lever toward you (“CANCEL”), or normal brake or
clutch pressure while slowing the vehicle will deactivate
the speed control without erasing the set speed from
memory. Pressing the (ON/OFF) button or turning off
the ignition erases the set speed from memory.
NOTE: For vehicles equipped with a manual transmis-
sion, depressing the clutch pedal will disengage the
speed control. A slight increase in engine RPM before the
speed control disengages is normal.
148 UNDERSTANDING THE FEATURES OF YOUR VEHICLE