Gastroback 40963 Design Food Processor S - Manual (Page 21)

53 53
• Take out the shaft. If you have used the universal ‘s’ blade or emulsifying disc, these
tools will come out with the shaft.
6. Empty the container.
7. Clean the appliance and all used parts and tools according to the instructions in chapter
„Care and Cleaning“.
Solving problems
If any problems occur during operation, you will find solutions in this section.
Problem Reason The Solution
The motor will not work, the
indicators in the ON/OFF or
PULSE button are dark.
The appliance is not live. Ensure that the plug is inserted
correctly and the power socket
is live.
The motor will not work,
the indicators in the ON/
OFF or PULSE button are
illuminated.
Bowl or lid is not locked
correctly.
Assemble the appliance com-
pletely and correctly according
to the instructions in section
„Preparing the Appliance“
The overheat protection
is active.
Switch OFF and unplug the
appliance. Wait for about 1/4
hour to let the motor cool down.
Thereafter, put the appliance
into operation again quite
usually. To avoid overheating,
do not apply too much pressure,
when pushing down your foods
in the feed tube. Cut firm foods
(e.g. carrots) in smaller pie-
ces, before processing. Make
brakes.
Suddenly the motor stops
during work.
The overheat protection
is active.
Switch OFF and unplug the
appliance. Wait for about 1/4
hour to let the motor cool down.
Thereafter, put the appliance
into operation again as usual.
To avoid overheating, do not
apply too much pressure, when
pushing down your foods in the
feed tube. Cut firm foods (e.g.
carrots) in smaller pieces, before
processing. Make brakes.