Gastroback 40963 Design Food Processor S User Manual

Page 15

8. Connect the appliance to the power supply. If the motor starts running, press the ON/OFF

button to stop it.
9. Switch on the appliance. The appliance processes your food in a few seconds. Thus, it

is sufficient for mixing and chopping of most foods to use the PULSE button in a few short

bursts. The motor will agitate only as long as you press this button down.

For kneading dough or ice mixtures or similar food, you need to operate the appliance for

some minutes. For this, use the ON/OFF button. However, even in this case, only a few

minutes of processing will be sufficient. Even kneading of yeast dough will be done in two or

three minutes.
10. Switch OFF the appliance, as soon as your food reaches the desired consistency.

Adding further ingredients

WARNING: Ensure not to spill any liquids on the appliance, when adding further ingre-

dients through the feed tube. Do not overfill the bowl. The maximum amount depends on the

type of processed food. Please refer to the table above.
11. If you wish to add further ingredients, it is best to switch OFF the motor first. Remove the

pusher and add the prepared ingredients through the feed tube. Then insert the pusher again

and switch ON the appliance.

Pushing down food that sticks to the inner sides

If food sticks to the inner sides of the bowl during processing, you should push it down in

between times. Refer to the instructions in section „After processing“, if you are not used to

handling the appliance.
WARNING: Always switch OFF and unplug the appliance before opening the lid. Do not

insert your hands in the bowl, if the bowl is mounted on the motor base. Do not scratch or

scrape on the surfaces of the appliance using hard or sharp-edged objects. Only use coo-

king utensils made of wood or plastic with the appliance.
12. First switch OFF and unplug the appliance. Remove the bowl (turn counter-clockwise

to the stop, then lift up). Open the lid (turn counter-clockwise to the stop, then lift up). Push

down the food. For this, use a wooden or a plastic cooking spoon.

Thereafter, re-assemble the lid on the bowl, re-assemble the bowl on the motor base, lock lid

and bowl and continue processing. In most cases, it is best to use the PULSE button in short

bursts. (See: „Tips for best results“)

Finishing Your Work

13. After you have processed your food as desired, switch OFF (indicators go out) and

unplug the appliance. Continue as described in section „After processing“.
14. Clean the appliance and all used parts and accessories immediately after use. Do not let

any food dry on the surfaces.