Gastroback 40963 Design Food Processor S - Manual (Page 16)

48
Grating, shredding and slicing using the cutting discs
The appliance is delivered with 2 different cutting discs. The blades
on the two sides of these discs are shaped differently, designated for
different purposes and, thus, providing different results. Therefore, it is
essential to assemble the cutting discs with the side facing upwards that
is provided with the required type of blades.
Tip: If you wish to process a large quantity or a partial separation
of the juice, it is best to use the large lid and the food collector. See:
Processing „Large quantities using the lid with feed and ejector chute“
Required Tools: Bowl, shaft, one cutting disc (depending on the desired
results), lid including pusher
Operating functions, buttons: Short-time operation; ON/OFF button or PULSE button
Maximum filling level:
750 ml
Usual operating time: A few seconds for each filling of the feed tube
Typical way of operation: Processing via the feed tube, processed food accumulates
in the bowl
WARNING: The knives of the cutting discs are very sharp. Handle with care!
Only grasp the cutting discs by the black plastic body or at the brim. Always assemble only
one single cutting disc. Do not attempt to use a cutting disc in combination with another
toolset simultaneously except for the separator disc when using the large lid (see: Working
Continuously Using the Large Lid).
Immediately wipe off spilled liquids. When liquids come out from under the lid, run down at
the exterior of the appliance and/or accumulate under the appliance, immediately unplug
the appliance to avoid injuries and damage caused by electricity. Clean and dry the appli-
ance, according to the instructions in section Care and Cleaning.
Do no not overfill the bowl. Always observe the maximum amount given in the table
above. However, if again liquids accumulate under the appliance, then possibly the bowl is
leaking. Get in contact with an authorized service centre for examination and repair.
Always remove the bowl from the motor base, before changing the tools or taking food out
of the bowl. This way, you avoid spilling food on / in the motor base. For this, unlock the
bowl (turn counter-clockwise as far as it goes), and then hold the bowl level while lifting it
up.
1. Prepare your food for processing. Remove all inedible or too hard parts (e.g. seeds,
shells, stalks, bones), and cut the food in appropriate pieces. Various hints for preparation
and processing are summarized in section „Tips for Best Results“.
2. Prepare the appliance for use, assembling the bowl.
(See: „Preparing the Appliance“)
3. Insert the short shaft in the bowl. Doing so, insert the pin in the middle of the shaft in the
opening in the middle of the bowl. If necessary, turn the shaft a little until it settles on the
coupling in the centre of the motor base.