Gastroback 40963 Design Food Processor S - Manual (Page 14)

46
Eggs 3 5-10 seconds hard-boiled; peel and cut into
quarters
Meats
(raw or cooked)
100 g 15-20 seconds cut into 2 cm pieces
Walnuts 100 g 10-15 seconds without shells, use halved or
broken; scrap down sides
of the bowl to ensure even
consistency
Onions 100 g 10-15 seconds peel and cut into quarters
Fresh herbs a few springs 10 seconds bowl and herbs must be com-
pletely dry; remove stalks
Potatoes 100 g 15-25 seconds cooked and peeled; cut into 3
cm cubes
Royal icing 280 g icing
sugar + 1 eggs
15 seconds
Processing with the universal ‘s’ blade
1. Prepare your food for processing. Remove all inedible or too hard parts (e.g. seeds,
shells, stalks, bones), and cut the food in appropriate pieces. Various hints for preparation
and processing are summarized in section „Tips for best results“.
2. Prepare the appliance for use, assembling the bowl. See: „Preparing the appliance“
3. Insert the shaft with the wide end facing downwards. Possibly you must turn the shaft a
little until it slips down.
4. Insert the universal ‘s’ blade only one orientation with the somewhat wider opening facing
downwards. Push it down on the shaft to the bottom of the bowl until it engages with a click,
but do not use violence! If you can not push the universal ‘s’ blade down, just turn it upside
down and try again. It is best to insert the universal ‘s’ blade always BEFORE inserting your
food in the bowl.
5. Add the prepared food but do not overfill the bowl.
Depending on the consistency of your food (firm or soft) you can process different amounts in
a single processing step. For example, if you wish to knead heavy dough using the univer-
sal ‘s’ blade, you should not add more than 300 ml. If your recipe requires adding further
ingredients later on, consider these additional amounts right at the start. (See: „Tips for best
results“)
6. Close the bowl with the lid.
Place the lid on the bowl with the protrusion on the lid lying at the right side next to the
handle of the bowl. Possibly turn the lid a little until it settles on the bowl. Then, turn the lid
clockwise until the protrusion is lying exactly over the handle of the bowl and the safety
interlock of the lid engages tangibly.
7. Insert the pusher into the feed tube.
NOTE: When connecting the appliance to the power supply with the ON/OFF button set to
ON, the motor starts running immediately!