Gastroback 41403 Design Mincer Plus - Manual (Page 21)

45
Storage
WARNING: Always switch off completely (ON/
OFF button and power switch), unplug and clean
the appliance and all its parts before storing (see:
›Care and Cleaning‹).
Ensure to store the appliance where it is clean, dry
and safe from frost, direct sunlight and inadmissib-
le strain (mechanical or electric shock, heat, mois-
ture) and where it is out of reach of young children.
Place the appliance on a clean and stable surface,
where it cannot fall. Do not place any hard or hea-
vy objects on the appliance or any part of it.
Always handle the power cord with care. Power cords may never be knotted, twisted,
pulled, strained or squeezed.
Do not use any parts or tools of the appliance for any other purpose than operating the
appliance. It is a good advice to store the parts and accessories of the appliance with the
appliance.
1. Always clean the appliance and its parts before storage (see: ›Care and cleaning‹).
2. It is good a advice to reassemble the cutter housing with cutter blade and a grinding disc
before storage, (See: ›Assembling the appliance‹) to avoid injuries by the cutter blade.
3. Additionally, you can insert some tools in the pusher (see picture Q). For this, remove the
cover of the pusher and place the tools into the interior, as shown in the figure. Then insert
the pusher in the feed tube of the cutter housing.
4. Carefully roll up the power cord without knotting or bending it. Then place the power cord
in the cord compartment in the bottom of the motor housing.
CAUTION: Do not carry the appliance by the tray or cutter housing. To move the motor
housing, always grasp it at both sides near the bottom.
5. Grasp the motor housing with both hands at its sides, and place it and all parts and tools
on a suitable surface, where it cannot fall, and is out of reach of young children.
Q