Gastroback 41403 Design Mincer Plus User Manual

Page 12

1. Take the worm housing into the right hand and

insert with your left hand the worm inside the worm

housing. (Picture E) The side of the worm with the

plastic end has to face the worm housing when

putting it inside the worm housing. The worm is

correctly assembled when the plastic end of the

worm stands a few millimetres out of the worm

housing. Take the adaptor disc. The small end with

the recess has to face the worm when attaching. If

necessary turn the adaptor disc a little bit until the

arresting pin of the worm housing locks precisely

into the corresponding recesses of the adaptor

disc.
IMPORTANT: If the tools overlap the edges of

the worm housing the worm is not placed properly

inside of the worm housing. Turn the worm a lit-

tle bit to make it fit inside but do not use force. If

mounted correctly the adaptor disc is aligned with

the front of the worm housing and the axis of the

worm stands out 2 mm of the adaptor disc.
Place the sausage attachment on the worm housing

and fit the closure ring over the sausage attach-

ment. Firmly screw the closing ring on the worm

housing and tighten by hand.
ATTENTION: Do not use any tools, for tightening

the screw and pay attention not to cant the screw.

If the screw cants the screw thread gets damaged.

If the screw does not turn easily put some sunflower

oil (or other edible oil) on the screw.
2. Firmly secure the worm housing in the opening

for the drive shaft. The small end of the worm hous-

ing has to face the mincer (picture F). Incline the

worm housing a little bit to the right, when assem-

bling it. When the worm housing is fitted all the

way into the opening of the drive shaft the release

button sinks into the motor housing. Turn the worm

housing counter clockwise until the shaft is facing

upright and is locked into place.

Note: When the worm housing is securely attached

you can hear a click sound and the release button

comes out of the recess again.
3. Press the feed pan onto the worm housing (pic-

ture G).
4. Place the pusher into the opening of the feed

chute (picture H).
The appliance is ready for operation.