Gastroback 41403 Design Mincer Plus - Manual (Page 20)

44
Do not leave any food dry up on the appliance or any parts of it to prevent a build up of
dried-on foods. Always clean the appliance after each use according to the following inst-
ructions.
Disassembling the appliance
WARNING!
Always switch off the ON/OFF button and power switch, wait until the
motor comes to complete standstill, and unplug from power outlet, before disassembling or
cleaning the appliance.
1. Switch off the ON/OFF button and power switch, wait until the motor comes to complete
standstill, and unplug from power outlet.
2. Remove the pusher. Then lift the tablet upwards to remove it.
3. Grasp the cutter housing with one hand, then press the release button near the gear hole
in the front plate of the appliance. (See: ›Knowing Your Design Mincer Plus‹)
4. With the release button pressed, unlock the cutter housing by turning it clockwise. Then
pull the cutter housing out of the motor housing.
5. Unscrew the screw ring.
6. Hold the cutter housing close over a plastic bowl or kitchen sink and carefully turn the
cutter housing with the outlet downwards. This way, the parts within the cutter housing will
fall out. Possibly, for this you must impress the gear of the worm shaft in the cutter housing.
Cleaning the appliance
WARNING:
The edges of the cutter blade are very sharp. Handle with care to avoid
injuries.
Do not use any abrasive cleaners, cleaning pads (e.g. metal scouring pads), or any corrosi-
ve chemicals (e.g. bleach) for cleaning the appliance or any parts of it, to avoid damage to
the surfaces. Do not immerse the motor housing or power cord in water or any other liquid.
Do not spill or drip any liquids on the motor housing, or on the power cord to avoid risk of
fire and electric shock. Do not use violence!
Do not place the appliance or any part of it in an automatic dishwasher!
1. Clean pusher, tablet, cutter housing, worm shaft, and screw ring, as well as any used tools
with warm dish-water and a nylon brush. If there are any tools within the pusher, take the
tools out first. Stubborn residues on the surfaces can be removed better by soaking in warm
dishwater for some minutes.
2. Moisture a clean cloth or soft sponge with a little warm dishwater and carefully wipe the
exterior of the appliance and the power cord.
WARNING:
Always ensure that the appliance and all parts of it are out of reach of young
children.
3. Thoroughly dry the motor housing and all parts, and let dry naturally for about half an
hour out of reach of young children.
4. It is good advice to lubricate the grinding discs and cutter blade with some vegetable oil.