Gastroback 40986 Vital Mixer Pro - Manual (Page 8)

48
49
• the appliance is for household use only.
movable and sharp-edged parts – risk of injury
• Never place the socket and / or the knife individually on the motor base. Do not touch the
drive wheel of the motor base with your hands when the power cord is plugged in. Do not
remove the blender jug from the motorblock whilst in operation.
• Always turn the appliance off (all buttons are deactivated), wait for the motor to stop mov-
ing and then pull the plug before removing the blender jug from the motorblock or taking off
the lid. It could take about 3 seconds until the motor has completely stopped. Never leave the
appliance ›On‹ when not in use.
• Never put your hands, wooden spoons or other foreign substance (such as hair, cloth,
brush, towels) into the blender jug when the motor is running or the appliance is connected to
the power outlet. Always take the blender jug off the motorblock first before you push down
the food with a spoon or add new ingredients.
• Ensure the appliance is properly assembled and that the blade is properly attached before
putting the plug into the power outlet. Do not operate the appliance without the lid or the inner
lid. Never place only the jug or the blade assembly housing only on the motorblock. Never
touch the drive gear when the plug is connected to the power outlet.
• Turn on the appliance only if the mixing jug with lid and inner lid are securely attached
and do not leave the appliance unattended during operation. If processing solid
ingredients (example: solid fruit and vegetables) or the jug is filled too full, the engine could
get stuck, stagnate or turn too slow. Immediately turn to ›0‹ (switch position: OFF) – the appli-
ance is turned off when all the keys have gone out – in order to avoid overheating. Observe
the instructions for trouble shooting (see: ›Trouble Shooting‹). Unplug the power cord and wait
for 1 minute so that the motor can cool down. Then you can continue working as usual.
important safeguards for all electrical appliances
• Always operate the appliance near a suitable wall power outlet and connect the appliance
directly to the power outlet. Do not use any extension cords or a multiple desk outlet.
• Ensure that the voltage rating of your mains power supply corresponds to the voltage
requirements of the appliance (230/240 V, 50/60 Hz, AC). Always connect the appliance
directly to a mains power supply wall socket with protective conductor (earth/ground) con-
nected properly. The installation of a residual current safety switch with a maximum rated
residual operating current of 30 mA in the supplying electrical circuit is strongly recom-
mended. If in doubt, contact your local electrician for further information.
• Do not leave the appliance unattended when connected to the power supply. Always turn
the appliance off (all buttons are deactivated) and immediately unplug the appliance after
operation and if it is not in use (even for a short break) and before cleaning and/or assembling
or disassembling. Always grasp the plug to disconnect the appliance from the power outlet.
• Fully unwind the cord before use. Always handle the power cord with care. Do not pull
or strain the power cord. The power cord may never be knotted or squeezed. Do not let
the power cord hang over the edge of the table or counter. Take care not to entangle in the
power cord. Do not touch the appliance with wet hands to avoid risk of electric shock. Do
not touch the appliance, if it is damp or wet or is touching wet surfaces while connected to
the mains power supply. In this case, immediately unplug the appliance and dry the appliance
(see ›Care and cleaning‹).