Gastroback 40986 Vital Mixer Pro User Manual

Page 22

Problem

Solution

The bottom of the blender jug untight-

ens during operation; liquid leaks.

Turn the appliance

›OFF‹ and pull the plug out of the power outlet. Empty the blender jug. Clean

and dry the motorblock. If any ingress of moisture into the motorblock or through the louvre take

the appliance for technical maintenance and repair to an authorised specialised reparation shop.
Ensure the blender jug is properly assembled.
Tip: Before filling liquid into the blender jug check if the blender jug is leak-proof by filling it

with water. Check the sealing ring. If necessary replace damaged parts by original spare parts

of the manufacturer.

It is not possible to get the blender

jug leak-proof; Liquid leaks from the

bottom of the blender jug.

Empty the blender jug. Disassemble the blender jug and check if there are crusts or damages on

the single parts. Clean the parts if necessary.
Replace damaged parts by original spare parts of the manufacturer.

Assemble the blender jug

according to the instructions. ATTENTION: Never use the appliance with improper or damaged

parts. Only use spare parts provided and made by the manufacturer. Contact you vendor for help.

The blender jug is screwed on too tight

to the holder.

Ensure to screw the holder counter-clockwise to get it loose.
Tip: It is easier to loosen the blender jug if you put a drop of vegetableoil onto the sealing ring.

Food is unevenly chopped

Either too much food is being chopped at one time or the pieces are not small enough. Try cutting

food into smaller pieces of even size and processing a smaller amount per batch. For best results

the food should be chopped into pieces no larger than 2cm.

Food is chopped too fine or is watery The food is over processed. Use brief pulses or process for a shorter time.
Food sticks to blade

Processing too much food. Turn the blender off and unplug the power cord. When the knifes stop

rotating, remove the blender lid and remove some food with a spatula.

The programs can not be selected.

Turn the rotary switch to the

›program‹ position (the three indicator lights flash blue). Now the

programs are selectable.