Gastroback 40126 Design Juicer Pro - Manual (Page 17)

Allow parts to air dry or thoroughly dry them with a clean cloth. Always assemble the appli-
ance completely before storing (regard ›Assembling the appliance‹). the parts are protected
this way and can not get lost. Keep all parts out of reach of children.
ATTENTION: occasionally clean the drive coupling (see picture) with a damp cloth. ensure
the stainless steel balls of the basket adjustment are clean and free from dried on juice or
pulp residue. After every fifth usage put some vaseline onto the balls of the adjustment.
wARNING: Please store the juicer in a frost-free, clean
and dry location where it is out of reach of children
and is protected against excessive loads (such as down-
fall, voltage, heat, humidity). Never lay heavy or hard
objects on top of the appliance.
TROUBlE ShOOTING GUIDE
Possible problem Easy solution
Machine will not work when
switched ›oN‹
Motor appears to stall when
juicing
excess pulp building up in
the micro mesh filter basket
Pulp too wet and reduced
extracted juice
Juice leaks between the rim
of the juicer and the cover
of the filter
Bowl surround juice sprays
out from spout
Juicer makes loud noise
when turned on
No juice coming out while
juicing
the safety locking arm may not be correctly engaged in the vertical oper-
ating position with the locking arm located into the two grooves on both
side of the juicer cover (regard ›Assembling the appliance‹).
Wet pulp can build up under the cover if the juicing action is too vigor-
ous. try slower juicing action by pushing the food pusher down more
slowly. clean the integrated pulp container, the stainless steel filter basket
and the juicer cover (regard ›to clear the block‹).
stop the juicing process. Remove the juicer cover, scrape off pulp.
Assemble and begin juicing again. try alternating (soft and hard) veg-
etable and fruit varieties.
try a slower juicing by pushing the food pusher down more slowly.
Remove stainless steel filter basket and thoroughly clean mesh walls with
the nylon brush. Rinse the stainless steel filter basket under hot water. If
the fine mesh holes are blocked, soak the stainless steel filter basket in a
solution of hot water with 10% lemon juice to unblock the holes or wash
in the dishwasher. this will remove excess fibre build up (from fruit or
vegetables) which could be inhibiting the juice flow.
try a slower juicing by pushing the food pusher down more slowly. Fruit
and vegetables with a high water content (tomatoes and watermelon)
should be juiced on low speed.
try a slower juicing by pushing the food pusher down more slowly.
Filer basket is not properly snapped into position. turn the ›oN/oFF‹
button to ›oFF‹. turn the power off. Disassemble the Design Juicer Pro
(refer to ›disassembling‹). Assemble (refer to ›Assembling‹).
check that the spout is not blocked with pulp. Refer to ›care and
cleaning‹.
49